cable length

英 [ˈkeɪbl leŋθ]

美 [ˈkeɪbl leŋθ]

链（英国608英尺，美国720英尺）；电缆长度；线长；电线长度

英英释义

noun

• a nautical unit of depth
  Synonym:cablecable's length

双语例句

• The propagation process of pulse wave in the cable and influence of cable length on overvoltage and wavefront time of winding are discussed in this paper.
  讨论了脉冲波在电缆中的传播过程以及电缆长度对线圈端的过电压和脉冲上升时间的影响。
• The effects of the change of the cable length and that the change of span on the middle-span sag of the cable are analyzed, and a comparison is made between the Parabola Linear Approximate Calculation Method and the Segmental Catenary Nonlinear Exact Calculation Method.
  分析了索股索长变化和跨度变化对索股跨中垂度的影响，并将抛物线线性近似计算方法和悬链线精确非线性计算方法进行了比较，发现两者计算结果较为接近。
• First, the initial status and the initial cable length were calculated by means of controlling the cable force and the internal force of all members in the pre-stressed state were obtained at the same time.
  首先通过控制索在预应力态下的张拉力求得零状态和索原长，并同时获得预应力态下所有单元的内力。
• According to the mechanic characteristics of this system, the bearing cable, the stress-free cable length of carry cable and the meticulous algorithm of suspension force of each span are given, and the influence of gentle cable elongation on its dead weight is presented.
  文中根据该系统的力学特点，给出了承重索、轨索的无应力索长和各跨吊杆力的精细算法，并计入了柔索伸长对其自重集度的影响。
• Place the units in their intended mounting locations to check the cable length and monitor installation conditions.
  把设备放入计划好的安装位置，检查电缆长度和监视器安装条件。
• The principle error of the TDR cable length measurement has also been analyzed. The influence of measuring numbers, counting pulse frequency and traveling wave velocity on measuring accuracy is analyzed.
  分析了时域反射电缆测长的原理误差，研究了测量次数、计数脉冲频率、行波波速对测量精度的影响。
• The calculation for construction control of the bridge is made with 3D Bridge program and the unstressed cable length method is used to control the final target status of the bridge in the spacial program.
  施工控制计算采用3DBridge进行，并在空间程序上利用无应力索长法控制斜拉桥最终目标状态。
• What is the maximum cable length between PC and camera ( s)?
  再PC与照相机之间的电缆最长是多少？
• In case the welding machine cannot be placed close to the welding area, enough cable length for both, the welding cable as well as the earth clamp has to be provided.
  如果焊机不能置于靠近焊接区，必须提供足够长度的焊接线以及接地夹。
• Meanwhile, a decision method for determine an unknown cable length also recommend.
  同时本文还向大家介绍一下未知电缆长度的电缆长度的简易判定方法。